November 19, 2011

Computer Components - Power furnish Unit

An foremost component of the computer is the Power furnish Unit (Psu). An electric power serves to change Ac current from your wall outlet into Dc current home as essential components of your computer. This gismo is placed at the end of the Pc casing and can be seen from the back of the Pc because it has a hole on Ac power and fan for cooling.

Type of voltage generated by power furnish was 3.3 volts. 5 volts and 12 volts. 12 Volt used to run the motor on the fan and disk drive, while the voltage from 3.3 to 5 volts used by digital circuits.

Brush Dc Motor Drive

An electric power source provides power to all devices on the Pc. This tool is an item that tends to damage. The damage is ordinarily due to excessive load. The ideas is not well grounded. Voltage is not garage and other causes.

One way to keep the tool is still functioning properly is to clean it regularly. Take off dust on the tool fan, or replace the fan if it has been damaged. Dust on the tool fan can cause the fan not to spin properly. If the fan can cause Pc damage damaged because the components become too hot (over heat).

If your electrical power source is damaged, look at the instructions / by hand book of your computer.

Some tips you can do if your power gismo was damaged as follows:

# 1 Turn off your computer, then use a brush to clean the power supply. To get the best result you can use a vacuum cleaner.
# 2 Open your Pc box, then disconnect all power connectors are plugged into the motherboard and other components.
# 3 Take off the electric power box than a Pc chassis for easy checking electronic circuit.
# 4 Uses a screwdriver to open the gismo box.
# 5 Cleans the dust on the electronic circuit board, examining the possibility of electronic components in them burned or separated from the circuit.
# 6 If the fan should be replaced, Take off the four bolts fan Psu by using a screwdriver and attach the new fan.
# 7 To install the new fan, heat and then melt tin solder on the underside of the circuit.
# 8 Replace the electronic circuitry and the fan into place originally. Measure voltage yellow wire (+12), blue (-12), red (+5), orange (Por) on the black cable. If the voltage parameters have shown a valid whole then you can use this gismo again.
# 9 Plugs the Psu into the Pc case and reconnects the power connectors and other components with the gadget.

If you want to replace the power supply, make sure the electricity has been turned off, even if your computer is not active, because this gismo can save electricity that could harm you.

Computer Components - Power furnish Unit

Electric Motors and Drives Basic Stamp 2 Module Homemade Chocolate Candy Recipes